Menu
Cart 0

Cobra Parkmaster flush fit parking sensors fitted to a SEAT IBIZA

Posted by Curtis Jacques on

Cobra Parkmaster R0394 flush fit rear parking sensors fitted to a SEAT IBIZA

One of this weeks jobs was fitting our Cobra flush fitting reverse sensors to a SEAT IBIZA. The SEAT IBIZA does usually require colour coded parking sensors due to the fact it has a matt black lip on the bottom of the bumper as this is where the factory fitted flush parking sensors would go so using our Cobra kit which is actually SEAT aftermarket OE equipment we set out to do the same.

The Cobra flush parking sensor kit was required over our Steelmate flush fit parking sensors due to the lower mounting position.  The Cobra Can be adjusted in various way to reduce sensitivity and detection distance.  Fitting took around 1 hour 30 minutes and we just unclipped the bumper to gain access to the lower valance on the SEAT IBIZA.

Once the Cobra flush fit parking sensors were fully fitted we adjusted just the outer two rear sensors and all was working as it should.  The finished installation looks identical to the factory OE flush parking sensors & our Cobra flush mount rear parking sensors were less than half the price at just £199.99 including mobile fitting at the customers address in Banbury Oxfordshire.

SEAT IBIZA flush fit parking sensors - Cobra R0394

 Flush fit parking sensors fitted to a SEAT IBIZA 2103


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.

Sale

Unavailable

Sold Out